ETC Element v2.1.0 - Manual (Page 57)

5
Setup 45
{Shutdown Macro}
This field allows you to set up a shutdown macro that will trigger at power off, not when exiting the
application.
{Cue Settings}
Click {Cue Settings} to enter this category.
You will be able to set the cue default times for intensity up and down.
{Show Control}
For more information on using show control with your system, see the Eos Family Show Control
User Guide, which is available for download at
www.etcconnect.com .
{SMPTE Time Code Rx}
This touchbutton is used to control whether your console can receive SMPTE time code. Choosing
“Disabled” will disable all time code lists that have a SMPTE source. The default for this setting is
“Enabled”.
{MIDI Time Code Rx}
As above, but for MIDI Time Code instead of SMPTE. The default for this setting is “Enabled”.
{Resync Frames}
This touchbutton allows you to configure how many frames need to be synced before timecode
starts running. Frames can be from 1-30. Default is 2 frames.
{MSC Receive}
This touchbutton toggles the setting for receiving MIDI Show Control from an external source
between “Enabled” and “Disabled”. The default setting is “Disabled”.
{MSC Receive Channel}
Also known as a “Device ID” this setting configures the MIDI channel for the console to receive
MIDI Show Control information. Only MSC data with the same device ID will be received. A device
ID can be from 0-126, or if set to 127, Eos Ti, Gio, Ion, or Element will receive MSC data from all IDs
(All Call). Eos cannot be set as an All Call receiver. For example:
• {MSC Receive Channel} [5] [0] [Enter]
{ACN - MIDI Rx ID(s)}
This setting allows you to specify the MIDI Show Control data that your console will receive when
transmitted over the Architecture for Control Network (ACN). When set, the console will respond to
MSC data from any gateway that has its “ACN MIDI Rx ID” set to the same number. ACN MIDI Rx
ID can be from 1-32. ID ranges may be used. When using the local MIDI ports on Eos Ti, Gio, Ion,
or Element, this setting needs to match the MIDI Rx Group ID in the ECU>{Settings}>{Local I/
O}>Show Control Gateway>Group IDs.For example:
• {ACN MIDI Rx ID} [2] [5] [Enter]
• {ACN MIDI Rx ID} [1] [Thru] [1][0] [Enter]
{MSC Transmit}
This setting, when enabled, allows the console to send MSC messages for actions taken on the
console, such as cue actions, macros firing, and submaster bumps. The default setting is
“Disabled”.
{MSC Transmit Channel}
Also know as “Device ID” this setting allows you to establish the device ID with which your console
will transmit MIDI Show Control information. A device ID can be from 0-126, or if set to 127, Eos,
Eos Ti, Gio, Ion, or Element will transmit MSC data to all IDs (All Call). For example: