ETC Element v2.1.0 - Manual (Page 93)

6
Patch 81
To add parameters to a new fixture:
Step 1: Use the [Page] keys to select the new fixture from the fixture list.
Step 2: Click {Edit}. That fixture will open in a new display in the CIA.
Step 3: Determine the total number of parameters that your fixture has. Do not count 16-bit
channels as two channels, this will be done in a later step.
Step 4: Click {New} to add parameter slots. Repeat this step until you have as many slots as
are required by the number determined in step 3.
Step 5: Use the [Page] keys to navigate to any parameter slots that you wish to alter the
default parameter designations.
Step 6: When you have selected a slot, click {Parameters}. The CIA will display buttons
representing all of the available parameters. The parameters are listed in alphabetical
order.
a: Click the {>>} and {<<} buttons to scroll through the available parameters.
The buttons on the left side of the CIA can be used to speed your search. You may click
them to see only parameters that fall into the specific categories of {Intensity}, {Focus},
{Color}, {Image}, {Form}, {Shutter}, or {Control}. {All} returns you to the complete list of
parameters.
b: Use the parameter category buttons on the left of the CIA to expedite
searching for a particular parameter.
N o t e : When {New} is clicked, the parameter slot will appear in the list with a default
name in the “Parameter” column. You may disregard these default parameters as
you will redefine the designations in a later step.