Kinze Ag Leader Integra - Manual (Page 101)

85
S
ETUP
S
ETTINGS
• Outside Boundary Option
Select one of the two options to determine system behavior when a section exits a field boundary.
• Coverage Option
In the Coverage Option area, you must choose between three options:
- The Minimize Skip option turns off the implement section after the entire section is fully inside your
coverage area. This prevents the possibility of skips.
- The Minimize Overlap option turns off the implement section when that section first enters your
coverage area. This prevents the possibility of overlaps.
- The User Defined option allows you to choose what percentage of the implement section is within the
coverage area before that section turns off. For example, if you choose 50%, then the section will
switch off when half of it is within your coverage area.
• Turn-On Look Ahead
This setting determines how far ahead the system looks to turn the sections back on. This setting
compensates for delay in the planting control system when the implement sections are turned on.
• Turn-Off Look Ahead
This setting determines how far ahead the system looks to turn the sections off. This setting compensates
for delay in the product control system when the sections are turned off.
Note: To use AutoSwath for planting operations, you are required to use a 5 Hz or higher GPS output rate.
AutoSwath control will not allow sections to be turned on until the master and planting section switches are
on. If you have less than a 5 Hz GPS output rate and you select AutoSwath, a warning appears, telling you
that AutoSwath Control is not available at less than 5 Hz.
V
EHICLE
O
FFSETS
Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > your
specific configuration > Setup (wrench) button > Vehicle Offsets button
After completing the process of setting up a Vehicle, you must configure vehicle offsets. The these
offsets define where the machine’s rear axle and hitch is in relation to the GPS antenna. These settings
are used by mapping.
The GPS Offsets settings consist of two tabs: the Antenna Tab and the Hitch Tab.
A
NTENNA
O
FFSETS TAB
At the Antenna Tab, enter the distance from locations on the vehicle to the antenna.
• Measure and enter the horizontal distance from the rear axle to the position of the GPS antenna. Select
IN FRONT or BEHIND to indicate the position of the antenna in relation to the rear axle.
• Measure and enter the horizontal distance from the centerline of the vehicle to the position of the GPS
antenna. Select LEFT or RIGHT to indicate the position from the vehicle centerline.
Configuration
Your Specific
Configuration
Vehicle Offsets