Kinze Ag Leader Integra - Manual (Page 68)

52 Firmware Version 5.2
Note: For more information on the Video screen, see “Video” on page 66 .
AutoSwath button. Pressing this button turns the AutoSwath feature on and off. When AutoSwath is
on, the icon is green; when it is off the icon is white.
AutoSwath - ON
AutoSwath - OFF
Area Logging Status button - This button appears for configurations that do not use rate control, such
as Tillage, Harvest, Planting operations that do not use SeedCommand, and Application operations that
do not use DirectCommand. Pressing this button turns logging on and off.
ON
OFF
The NORAC Engage button enables boom height control. This button can toggle back and forth
between Automatic Mode and Manual Mode.
When you enable Automatic Mode, this button turns green with three lines appearing underneath the
triangle. At the same time, the display beeps three times.
When you disable Automatic Mode on any part of the boom and the display switches to Manual Mode,
this button turns grey and the display beeps twice. If less than the full boom remains in Manual Mode,
the display will continue beeping twice every three seconds.
NORAC Engage - Enabled
NORAC Engage - Disabled
The Engage icon shows that the autosteer system is on, off, or off but ready to engage. The appearance
of this icon displays the following:
Engage - ON
Green if the autosteer system is on.
Engage - Ready
Grey if the autosteer system off but ready to engage.