Kinze planter monitor module, Kinze planter configuration, Kinze p – Kinze Ag Leader Integra User Manual
Page 219: Lanter, Onitor, Odule
203
P
LANTING
KINZE P
LANTER
M
ONITOR
M
ODULE
P
LANTING
KINZE P
LANTER
M
ONITOR
M
ODULE
The KINZE Planter Monitor Module is a feature that displays planting data from a KINZE Population
Monitor on the Map screen.
Note: Steps 1-4 must be performed by everyone who has purchased a KINZE Planter Monitor; steps 5-6 are
performed by customers who have purchased those specific features.
1. KINZE Planter Monitor Module Configuration
This creates a configuration that is used for KINZE Planter Monitor operations.
2. Monitor Module setup
Included front and rear unit settings, Shaft RPM sensor settings, and row spacing settings. This step allows
the display to detect the physical KINZE Planter devices.
3. Sensor detection process
This allows the display to detect the proper number of muxbus sensors on the row units. For more
information, see
“Muxbus Sensor Detection” on page
4. Set alarm thresholds
This allows user-defined level at which the seed monitor alarms will sound. For more information, see
“Alarms on KINZE Planter Monitor” on page
.
5. Calibrate the Magnetic Pickup Coil
This step, which is performed by customers who have purchased the Magnetic Pickup Coil Speed Sensor
allows the Monitor Module to receive data from this sensor, which measures the ground speed of the
planter. For more information, see
“KINZE Magnetic Coil Speed Sensor Calibration” on page
.
6. EdgeVac® calibration
This step, which is performed by customers who have purchased the EdgeVac® seed meters, allows the
display to receive accurate data from the meters. For more information, see
KINZE Planter Configuration
Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > your
specific configuration > Setup (wrench) button > Seed Monitor button > Planter Configuration button
Configuration
Select Your Specific
Configuration
Seed Monitor
Planter Configuration