Bay Technical Associates BayStack 400-ST1 - Manual (Page 20)

18
Figure 8. Installing a 400-ST1 Cascade Module
4. Press the module firmly into the chassis slot. Be
sure that the module is fully seated into the mating
connector.
5. Secure the module in the chassis by tightening the
thumb screws on the module front panel.
6. Repeat Steps 1 to 5 for each switch that is to be
configured with the 400-ST1 Cascade Module.
7. Proceed to the next section “Installing and
Connecting Multiple Switches ” on page 19 .
Caution: Be sure that the module slides in on the
guides provided. Failure to align the guides could
result in bent and broken pins
Cascade A Out
Cascade A In
Unit Select Base
BS0037A