Bay Technical Associates BayStack 400-ST1 - Manual (Page 27)

25
Figure 11. Verifying the Installation
• The Base LED for the base unit only is on.
If one (or more) Base LEDs are blinking, no unit (or
more than one unit) is configured as the base unit.
If the LEDs on any of the units in the stack are not as
shown in
Figure 11 , cycle the power to the stack and verify
the LEDs. Refer to Using the BayStack 450 10/100/1000
Series Switch guide to set up the stack and for detailed
information about stacking, including troubleshooting.
450-24T Switch
12 11
24 23
BayStack
Cas
BS0040A
Cas
Up
Dwn
Base
Pwr
Status
RPSU
Cas
Up
Dwn
Base
Pwr
Status
RPSU
1 = Base unit only
2 = All other units in stack
1 2