Bay Technical Associates BayStack 400-ST1 - Manual (Page 29)

27
Assigning a New Base Unit to the Stack
To assign a new base unit to the stack, complete the
following steps:
1. Set the Unit Select switch on the original base unit
to the Off position.
See Figure 9 on page 20 for details about the Unit
Select switch.
2. Set the Unit Select switch on the new base unit to
the Base position.
3. Renumber the Stack.
See the Using the BayStack 450 10/100/1000 Series
Switch guide for detailed information on how to
renumber the stack configuration.
Note: Bay Networks recommends that you
always configure the top unit in the stack as the
base unit.