Lenze PLC Designer Migration PLC Designer (R2-x)-PLC Designer (R3-x) - Manual (Page 8)

Safety instructions
8
Lenze · PLC Designer | Migration of V2.x projects · 1.2 EN - 02/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3 Safety instructions
Please observe the following safety instructions when you want to commission a controller or sys-
tem using the L-force Controller.

Read the documentation supplied with the corresponding field device thoroughly before
starting to commission the devices with the L-force Controller!
The device documentation contains safety instructions which must be observed!

Danger!
According to our present level of knowledge it is not possible to ensure the absolute free-
dom from errors of a software.
If necessary, systems with built-in controllers must be provided with additional monito-
ring and protective equipment according to relevant safety regulations (e.g. law on tech-
nical equipment, regulations for the prevention of accidents), so that an impermissible
operating status does not endanger persons or facilities.
During commissioning persons must keep a safe distance from the motor or the machi-
ne parts driven by the motor. Otherwise there would be a risk of injury by the moving
machine parts.

Stop!
If you change parameters in the »Engineer« or the »WebConfig« while a device is con-
nected online, the changes will be directly accepted by the device!
A wrong parameter setting can cause unpredictable motor movements. By unintentio-
nal direction of rotation, too high speed or jerky operation, the driven machine parts may
be damaged!