MTS Criterion Series 40 - Manual (Page 71)

For this example, select mm for the Crosshead meter. Right-click the Crosshead meter and select Unit
> mm.
3. Change the load Meter Type to Running Maximum/Minimum.
Right-click the meter labeled “Load” and select Meter Type > Running Maximum/Minimum. You will
use this meter to monitor the maximum and minimum forces imparted on the specimen during installation
to ensure that the specimen is undamaged at the conclusion of specimen installation.
4. Zero the load meter.
Right-click the load meter and select Zero Signal. The meter will show a value near zero.
MTS Criterion ™ Series 40 | 71
Running the Example Tension Test