Bunn CDS-3 - Manual (Page 15)

15
AUGER ASSEMBLY & DISASSEMBLY (EARLY AUGERS ONLY)
The augers may look intimidating at first glance. But there are really just a
few pieces snapped together. Please familiarize yourself with this procedure. It’ll
make cleaning and routine maintenance easier. The augers should be taken apart
for cleaning and then reassembled for use.
Auger Sections (3 req’d.)
Auger Nose
Short Auger Latch
Long Auger Latch
ASSEMBLY
1.
Snap one of the auger sections
to the long auger latch.
2. Snap another auger section
in place.
3. Snap the third auger
section in place.
4. Snap the auger nose onto
the last section installed.
5. With the long auger latch on
top, place the short auger
latch inside the augers and
snap it onto the assembly.
DISASSEMBLY
1. Firmly pull the auger section connections apart at each slot in the long auger
latch.
2. Firmly pull the connection between the auger section and auger nose apart.
3. Separate the slots in the short auger latch as you remove the auger sections.
27646 022500