Oyen Digital DATATALE RC-M4QJ 4-BAY RAID - Manual (Page 23)

23
RAID CONFIGURATION
To assign and create the RAID System’s inserted hard drives into a preferred
RAID Mode, using the LCM only, please follow the steps listed in the instructions
provided below:
1. Turn ‘On’ the RAID System. After “initializing”, it will display “DataTale
ONNTO Corp.”. Under Main Menu, press Down Button (∨ ∨ ∨ ∨ ) to select
‘Quick Setup’ and press Enter (↵ ↵ ↵ ↵ ).
Main Menu
Quick Setup
2. Select ‘Create One RAID’ and press Enter (↵
↵ ↵ ↵ ).
Create One RAID
Quick Setup:
3. Use the Up (∧ ∧ ∧ ∧ ) and Down Buttons (∨ ∨ ∨ ∨ ) to select which RAID Mode to use.
Select Level:
RAID 0
If not enough hard drives are inserted inside the RAID System, then it
will display “Disk Not Enough, Cannot Create!”