Oyen Digital DATATALE RC-M4QJ 4-BAY RAID - Manual (Page 51)

51
RAID SETTINGS
To setup the RAID Standby Timer Settings and RAID Rebuild Priority Settings,
please complete using the following steps:
1. Under the last sub-menu (bottom), select to go into the RAID Settings.
Write in the amount of minutes preferred under “Please enter a value
between 0 and 10922 (minutes)” for RAID Stand-by Timer Settings. Once
set, after idling for the specified minutes, the RAID disks will enter into the
stand-by mode.
2. Adjust the slider bar under “Please select a value from the slider” by going
left or right. Left side indicate “low” and right side indicate “high” for speed
of rebuilding and will affect the speed of data transfer based on set
preference. The higher the RAID Rebuild Priority, the quicker the rebuild
speed, and the slower the data access and transfer speed.
3. After entering preferences, click on the “Apply” icon to begin the process.
Once completed, a popup window stating “Apply the RAID standby timer
settings successfully. Apply the RAID rebuild priority settings successfully”
will appear to confirm. Click on the “Ok” icon to re-confirm.