RKI Instruments GX-2003 Manual - Manual (Page 34)

27 • Display Mode GX-2003 Operator’s Manual
ID Screen
This screen displays only if USER/STATION ID in the Setup Mode
menu is set to ON (see “Turning the User/Station ID Function On or
Off” on page 61). Each ID contains 10 characters. Uppercase letters,
numbers, asterisks (*), dashes (-), and a blank space are available
characters.
Use this screen to identify the user, location, or other information. The
user ID and station ID provide a way to identify the user and location
of exposure during a data logging session. The user ID and station ID
are saved to the data logger for that session when you turn off the GX-
2003, so you can update the ID’s for each data logging session if
desired.
To enter a user and station ID:
1. After entering Display Mode and proceeding to the ID screen,
press and hold the (SHIFT) button, then press the DISPLAY (ADJ)
button and release both buttons.The first character under USER ID
flashes (* is default).
2. Press the ▲AIR and (SHIFT)▼ buttons to scroll through the
available characters. (The asterisk, dash, and blank space are
between the set of letters and numbers.)
3. When the desired character displays, press and release the
POWER ENTER button to enter the character and go to the next
character.
NOTE: To exit the ID screen while entering characters without saving
the updates, press the DISPLAY (ADJ) button twice. You will
advance to the peak screen without saving any ID updates.
4. Repeat steps 2 and 3 for the remaining 19 characters. When the
final character of the station ID is entered, then both ID’s are
saved.
5. Press and release the DISPLAY(ADJ) button to advance to the Peak
Screen.
USER ID
*********
STATION ID
*********
21:09