Regency Panorama P33E Small Gas Fireplace - Manual (Page 37)

Regency® P33E-4 Zero Clearance Direct Vent Gas Fireplace
37
INSTALLATION
Diagram 1
Diagram 3
STANDARD FLUSH
DOOR
The standard fl ush door comes with a black
frame. To install the frame, simply hook the top
door fl ange onto the top of the unit and swing
the door towards the unit, diagram 1. Be careful
that the glass gasket does not roll up; there must
be a gap between the gasket and the door lip to
ensure that the door sits securely on the unit.
See Diagram 2.
Diagram 2
5th Grate Tab
6) Place the bottom left front edge of Log 251
against the left edge of the burner tray and
rest the log on the cutout on Log 253.
7) Position Log 252 across the cutouts in Logs
254 and 253. The notch in the bottom right
end fi tting against the 5th grate tab.
8) Pull off ember size pieces of rock wool and
gently place them on the front of the burner
tray in the places shown in the photo below.
Do not compress the rock wool, leave it
loose.
Separate platinum embers and place them
on the front of the burner on and around the
rock wool.
Place rock wool in these 2 locations
on the burner tray. 251
252
250
254
253
250
254 253
251
253
250
254
253 254
252
Cutout
9) Test fi re to ensure proper light off (make
sure fl ame fl ows smoothly from one end of
burner to the other). If there is any fl ame
hesitation, check that area for any blockage
of the burner ports.
Use the hook to pull the spring out until you
can put the hook into the slot on the bottom
door bracket. Repeat for 2nd spring. See
diagram 3.
To remove the fl ush door, reverse the above
steps.
OPTIONAL FLUSH
TRIM
Attach the round magnets to the back of the
top trim piece and to the bottom trim piece,
then attach trim to the top and bottom of
Flush door.