Regency Panorama P36E Medium Gas Fireplace - Manual (Page 36)

P36E-4 Zero Clearance Direct Vent Gas Fireplace 36
CONVERSION FROM NG TO LP
FOR P36E-4 USING SIT 886 GAS VALVE
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!
Each Kit contains one LPG
Conversion Kit #514-972
LPG Conversion Kit Contains:
Qty. Part # Description
1 904-390 Burner Orifi ce #52
1 918-590 Decal "Converted to
LPG"
1 908-528 Red "LPG" label
1 904-529 5/32" Allen Key
1 911-009 Hi/Lo regulator
1 910-101 LPG Injector (Pilot Orifi ce)
1 918-861 Instruction Sheet
Remove the 2 screws, push Burner
Assembly to the left and lift out.
Installation of the LPG
Conversion Kit:
1) Shut off the gas supply.
2)
a) Remove the louvers, bay door or
faceplate if installed.
b) Open the fl ush door and remove the
door.
c) Remove the logs, embers, and brick
panels (if used).
7) Reinstall new burner orifi ce LPG
stamped #52 and tighten
8) Remove Hi/Lo pressure regulator by
removing 2 screws as shown below.
Reverse steps to install LP pressure
regulator.
9)
Attach the label “This unit has been
converted to LPG” near or on top of the
serial # decal.
10) Replace yellow “NG” label with red
“LPG” label.
11) Reverse steps 3 - 1.
12) Check for gas leaks.
13) Check inlet and outlet pressures.
14) Check operation of fl ame control.
4) Pull off the pilot cap to expose the pilot
orifi ce.
5) Unscrew the pilot orifi ce with the allen
key; then replace with the LPG pilot
orifi ce and the pilot cap, provided in the
kit.
6) Remove burner orifi ce with a 1/2"
wrench. Use another wrench to hold on
to the elbow behind the orifi ce. Discard
orifi ce.
Burner Orifi ce
Remove the 2 screws, push Burner Assembly
to the left and lift out.
3) Remove the 2 screws holding the Burner
Assembly to the fi rebox base. Push the
Burner Assembly to the left and lift out.
For P36E-4 Only:
For U32E-5 Only:
3a) Remove the grate by removing the
screws on each side of the grate.
Remove the 2 screws,
push Burner Tray to the left, and lift off.
Remove the 2 screws
holding the grate in position.
3b) Remove the Burner Tray by removing
the screws on each side of the tray.
Push the tray to the left and lift up.
Installer Notice:
These instructions must be left
with the appliance.
INSTALLATION