Wasp Barcode WLS9600 Product Reference Guide - Manual (Page 73)

ENTER/EXIT PROGRAMMING MODE Set Global Mid Label ID Characters
Product Reference Guide 63
Label ID Symbology Selection (continued)
Set Anker Plessey Label ID Character(s)
Set Code 4 Label ID Character(s)
Set Code 5 Label ID Character(s)
Set Global Mid Label ID Characters
Specifies mid-label ID that is added for transmission between the labels of a two-label pair.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE barcode above
to place the unit in Programming Mode, then the “Set Global Mid Label ID Character(s)”
barcode followed by the digits (in hex) from the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). If less than the expected string of 20 characters are
selected, scan the ENTER/EXIT barcode to terminate the string. Exit programming mode by
scanning the ENTER/EXIT barcode again.
Set Global Mid Label ID Character(s)
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the beginning.
CANCEL
DEFAULT No Mid Label ID
Character (00)