Scanning active time, Flash on time, Scanning active time flash on time – Wasp Barcode WLS9600 Product Reference Guide User Manual
Page 84: Canning, Ctive, Lash, Default
Scanning Features
ENTER/EXIT PROGRAMMING MODE
74
WLS9600
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the state is
entered. The range for this setting is from 1 to 255 seconds in 1-second increments. See
in “References” for descriptions of each feature
Select Scanning Active Time Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
CANCEL
DEFAULT
005 = Scanning is active for 5 Seconds
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode. The selectable
range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments.See
in “References” for detailed information on setting this feature.
Select Flash ON Time Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
CANCEL
DEFAULT
10 = Flash is ON for 1 Second