Wasp Barcode WLS9600 Product Reference Guide - Manual (Page 82)

LED and Beeper Indicators ENTER/EXIT PROGRAMMING MODE
72 WLS9600
Good Read LED Duration
This feature specifies the amount of time that the Good Read LED remains on following a good
read. The good read LED on time can be set within a range of 10 milliseconds to 2,550
milliseconds (0.001 to 2.55 seconds) in 100ms increments.
See page 253 in “References” for detailed instructions and examples for setting this feature.
Select Good Read LED Duration Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
CANCEL
DEFAULT 003 = Good Read LED stays on for 300 ms
Indicators are dimmed during sleep.