Wasp Barcode WLS8600 Product Reference Guide - Manual (Page 52)

Enter Configuration Exit and Save Configuration
М$+;О
DATA FORMAT
М$-?О
CHARACTER REPLACEMENT
 disable character replacement
ÌEO0mÎ
This parameter allows up to three characters to be replaced from the barcode read. These
substitutions are stored in memory. To define each character replacement:
 Read one of the following character replacement codes:
first character replacement
ÌEO1pÎ
second character replacement
ÌEO2sÎ
third character replacement
ÌEO3vÎ
 From the Code Identifier Table in Appendix B , read the Code Identifier for the desired
code family.
0 = character replacement will be effective for all code families.
 From the Hex/Numeric Table read two characters corresponding to the Hex value
( 00-FE), which identifies the character to be replaced. For Wedge and USB-KBD
interfaces, it is also possible to read the Special Key(s) on page 42.
 From the Hex/Numeric Table read two characters corresponding to the Hex value
( 00-FE), which identifies the new character to replace. For Wedge and USB-KBD
interfaces, it is also possible to read the Special Key(s) on page 42.
FF = the character to be replaced will be substituted with no character, that is, it will be
removed from the code.
46