Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1.3 - Manual (Page 102)

WI-I/O 9-L Configuration Manual
WI-I/O 9-L Wireless I/O page 102 of 108
6. To view additional information about a message, select the message line with the mouse.
WI Series shows additional information about the message at the bottom of the screen
including the system address, RSSI and CRC (i.e. error-check) status.
The “text box” in the bottom middle of the screen decodes the message to display the I/O
channel and value.
Note
To completely decode the message, you must open the same configuration project
corresponding to the system being monitored.
You can also display the register values as:
Decimal – by selecting Dec .
Digital – by selecting Dig. WI Series displays the value as a 0 or 1 digital value (1 if
the 16-bit value is greater than 50% - i.e. the most significant bit is 1).
Analog – by selecting Anlg . WI Series displays the value as a 4-20mA range.
Note
To stop decoding “comms logging”, click Stop Comms .
Other options allow data to be logged to a file, so that the data can be reviewed at a
later time (Open Log File).
Note
Debug I/O is not used on the WI-I/O 9-L modules.