Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1.3 User Manual
Page 50
WI-I/O 9-L Configuration Manual
WI-I/O 9-L Wireless I/O
page 50 of 108
8. WI Series loads the contents of the connected module and may show one or more of
the following errors:
Error
Description and action
If there is no module connected to the serial
port you have selected or WI Series cannot
communicate with the module the following
message is shown:
Click
OK
to acknowledge the message and
check the power to the module, the comm
port selected and the serial
cable/connections to try again.
If the module connected to the serial port
has the same unit address as one already
in the system, WI Series will show the
following message if either the unit or the
module does not support secondary
addresses (i.e. either one is not transmit
only):
Click
OK
to acknowledge the message and
return to the previous screen without
loading the module.
If the module connected to the serial port
has the same unit address as one already
in the system but both the unit and the
module support secondary addresses, WI
Series will show the following message:
Click
OK
to acknowledge the message and
continue loading the module or
Cancel
to
return to the previous screen without
loading the new unit.
If the module connected to the serial port
has the same secondary address as one
already in the system, WI Series will show
the following message:
Click
OK
to acknowledge the message. If
you choose to continue loading the module
check that you have the correct module
connected. The new unit will retain the
module’s unit address and will be assigned
the lowest unused secondary address for
that unit address.
If the module connected to the serial port
has a different system address to the one
already assigned to the system, WI Series
will show the following message:
Click
OK
to continue loading the unit or
Cancel
to return to the previous screen
without loading the module configuration.
If you choose to continue you will be asked
whether you want to modify the system
address of the system to match that of the
module you are loading:
Click
Yes
to change the system address to