Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1.3 - Manual (Page 6)

WI-I/O 9-L Configuration Manual
WI-I/O 9-L Wireless I/O page 6 of 108
Safety information
Thank you for selecting the WI-I/O 9-L for your telemetry needs. We trust it will give you many years of valuable service.
To ensure your WI-I/O 9-L enjoys a long life, double-check
ALL your connections with the Installation Guide before
powering on the module.
WARNING : Incorrect termination of supply wires may cause internal damage and will void warranty.
Exposure to RF energy is an important safety consideration. The FCC has adopted a safety standard for human exposure
to radio frequency electromagnetic energy emitted by FCC regulated equipment as a result of its actions in Docket 93-62
and OET Bulletin 65 Edition 97-01.
FCC Notice when used in USA: WI-I/O 9-L Wireless I/O Module
Part Additional information
15 This device has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part15 of the FCC rules (Code of Federal Regulations 47CFR Part 15). Operation is subject to the condition
that this device does not cause harmful interference.
90 This device has been type accepted for operation by the FCC in accordance with Part90 of the FCC rules
(47CFR Part 90). See the label on the module for the specific FCC ID and any other certification
designations.
Industry Canada: WI-I/O 9-L Wireless I/O Module
RSS-119 - This device has been type accepted for operation by Industry Canada in accordance with RSS-119 of the
Industry Canada rules. See the label on the module for the specific Industry Canada certification number and any other
certification designations.
NOTE : Any changes or modifications not expressly approved by Weidmuller, Inc. could void the user’s authority to
operate this equipment.
To operate this equipment legally the user must obtain a radio-operating license from the government agency. This is
done so the government can coordinate radio users in order to minimize interference.
Safety information - FCC Notice
This device complies with Part 15.247 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference; and
This device must accept any interference received, including interference that may cause undesired operation
NOTE : This equipment is suitable for use in Class 1 Division 2 groups A, B and C or non-hazardous locations only.
In order to comply with Electrical Safety Regulations, this module must be installed in an Electrical AND
Fire enclosure. This enclosure may be a single or multiple enclosures. Access to the module is to be
made by a Service Person only.
**IMPORTANT ELECTRICAL SAFETY INFORMATION**