Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1.3 - Manual (Page 71)

WI-I/O 9-L Configuration Manual
WI-I/O 9-L Wireless I/O page 71 of 108
! 4 &
Pulsed inputs let you count the number of transitions occurring on an input or the rate those
transitions occur.
WI Series lets you set:
Pulsed input rate – detects the rate of transitions on an input.
Note
The WI-I/O 9-L-T does not support pulsed input rate.
Pulsed input count – that counts the number of low-to-high transitions occurring on
the input. The WI-I/O 9-L-T lets you set the number of transitions that must occur
before a ‘change of state’ occurs and any mappings using the pulse count are
triggered.
To set unit pulsed inputs:
1. Open the project.
2. Select the WI-I/O 9-L-T unit you want to change.
3. Select
Pulsed Inputs .
4. WI Series shows the Pulsed Inputs page:
5. Select the Count tab (the Rate tab has no entries to select).
6. Double click the Pulsed Input you want to change or select the Pulsed Input and click
Edit .