Rockwell Automation 160PD1 160 Profibus Communication Module - Manual (Page 14)

3–4 Installation and Wiring
Figure 3.3
Communication Module Installation
Removing the PD1 Module
If you need to reconfigure the PD1 Module rotary switches, you must
remove the module from the drive.
1. Verify that all power to the drive is removed. Review Attention
statement on page 3–3.
2. Disconnect the cable/connector from the module (if present).
3. Press in on the module’s latch and then push away and up.
4. Grasp the module and pull straight up. Avoid bending or twisting
the contact pins located underneath the center portion of the
module.
Figure 3.4
Removing the Communication Module
Latch must be in this position before
installation. Once installed, push the
latch down until it locks into place.
Module should be flush
with top surface of drive