Rockwell Automation 160IB1 InterBus Communication Module - Manual (Page 13)

Installation and Wiring 3–3
Figure 3.2
Communication Module Installation
Removing the IB1 Module
If you need to remove the module from the drive, you must
1. Verify that all power to the drive is removed. Review Attention
statement on page 3–2.
2. Disconnect the cable/connector from the module (if present).
3. Press in on the module’s latch and then push away and up.
4. Grasp the module and pull straight up. Avoid bending or twisting
the contact pins located underneath the center portion of the
module.
Figure 3.3
Removing the Communication Module
Latch must be in this position before
installation. Once installed, push the
latch down until it locks into place.
Module should be flush
with top surface of drive