Rockwell Automation 1403-NSC Smart Communication Card Instruction Sheet - Manual (Page 3)

3 Smart Communications Card
Publication 1403-5.1
Installation
!
ATTENTION: Please follow
appropriate ESD procedures before
removal and/or installation of the Smart
Communications Card. Failure to follow
these procedures can result in physical
damage to both the Smart
Communications Card and the Master
Module.
1. To remove the blank plate on the Master Module,
unscrew the two corner retaining screws as shown in
Figure 2. Save these two screws for reassembly.
Figure 2.
2. If you plan to remove the communications card at a
later date, retain the blank plate. Otherwise, dispose
of properly.
3. Remove the communications card from the static
protection shipping bag.
4. Grasp the card with the components side up and the
three LEDs on the left. Place the right index finger in
the top notch and the thumb in the bottom notch.
5. With the Master Module labels right side up, place
the card into opening on the left side. The card to
Master Module connector should align properly when
the top right and bottom left guide pins of the Master
Module mate with holes in the card. With your left
thumb, press just above the card to Master Module
connector to attach the connector. Tighten the four
corner screws.
Figure 3.
6. Place the closure plate over the opening and secure it
with the two screws from the original blank plate.
Figure 4.
Note: Refer to Appendix E, Specifications for screw
torque requirements and wire sizes.