Rockwell Automation 1395 Reel Tension Paster Adapter - Manual (Page 23)

Publication 1395-RTP-5.1 - September 1997
Start-Up Instructions 3-3
ITS (Download)
To download from ITS to Drive:
From Main Menu,
Select “Drive Data”,
Select “Edit” ENTER key,
Select “Parameter”, (cursor through Parameters), make changes,
ESC,
Select “EEPROM”, ENTER key,
Select “Save”, ENTER key
DHT (Hand-Held Programming Terminal)
From Main Menu,
Select “Parameters”,
Type Parameter number, ENTER key,
Arrow-down cursor to value and type new value, ENTER key,
When changes are completed, depress “MENU” key,
The DHT will prompt “SAVE CHANGES”?
Select “Yes”, ENTER key
Start-Up Checklist Verify J6 and J7 jumpers on the Digital Reference Adapter Board are
in Position 1-2.
Verify J1 jumper on Feedback section of the PSI/Switcher Board of
the 1395 Drive is in Position 3.
Verify J8, J9, and J10 jumpers on the Main Control Board of the 1395
Drive to be in Position 1-2 (Figure 3-1).
Verify burden resistors on Feedback Board to be 25.2 Ohms on TB1
and 80 Ohms on TB3, for a 1395-B68, or, 13.8 Ohms on TB1 and
45.9 Ohms on TB3 for a 1395-B70.
Verify incoming AC line to Drive, L1, L2, and L3, to 380 or 460
VAC, ± 10%.