Installation, Chapter, Installation check list – Rockwell Automation 1608P-200A480V... HC-DySC User Manual User Manual
Page 7: Inspecting and unpacking, Location (environment), System components
Rockwell Automation Publication 1608P-UM005A-EN-P - November 2014
7
Chapter
2
Installation
Installation Check List
Before proceeding, take a few minutes to review the necessary steps to install your
HC-DySC.
•
All packing materials and restraints have been removed.
•
The HC-DySC is placed in its installed location.
•
All conduits and cables are properly routed to the HC-DySC.
•
All power cables are properly terminated.
•
A ground conductor is properly installed and terminated.
•
If neutral connection is required, that it is properly terminated on the
HC-DySC.
•
The area around the installed HC-DySC is clean and dust-free.
•
Adequate work space exists around the HC-DySC.
•
Adequate lighting is provided around the HC-DySC.
•
Operational checks have been reviewed and completed.
Inspecting and Unpacking
•
Lift only at the base with a fork truck or pallet jack.
•
Carefully inspect the outer packaging for evidence of damage during
transit. Do not install a damaged cabinet. Report any damage to the carrier
and contact your local sales or service immediately.
•
Check the HC-DySC label for correct model number with the packaging
list to verify you have received the correct voltage, current, and wiring
configurations.
•
After removing the packaging material, inspect the contents for any
evidence of physical damage, and compare each item with the Bill of
Lading. If damage has occurred or shortages are evident, contact your
carrier immediately.
Location (Environment)
Install the HC-DySC in a protected environment. The location must provide
adequate airflow around the HC-DySC in an atmosphere free from excessive
dust, corrosive fumes, or conductive contaminants. Do not operate the HC-
DySC in an environment where the ambient temperature or humidity is beyond
the specified limits that are given in this manual.
System Components
The HC-DySC consists of one enclosure with an integral maintenance bypass
switch to prevent power disruption during service and maintenance.