Rockwell Automation 1786-RPFRXL ControlNet Fiber Ring Modules Installation Instructions - Manual (Page 12)

12 ControlNet Fiber-optic Ring Repeater Modules
Rockwell Automation Publication 1786-IN003D-EN-P - April 2011
Figure 3 - Mounting Dimensions
Horizontal mounting requirements are determined by using the following
formula:
RPA/B width + (4.2 inches x number of RPFR(X)L + 2 inches
For more information, see the ControlNet Modular Repeater Adapter
Installation Instructions, publication
1786-IN013 .
Do these steps to mount a module.
1. Position the module on a 35 x 7.5 mm (1.38 x 0.30 in.) DIN rail,
Allen- Bradley part number 199- DR1; 46277- 3; EN 50022).
IMPORTANT Maintain adequate separation from other equipment to
guarantee that ambient temperature is within the operating
range of this module. You must follow applicable separation
codes for safe operation.
Dimensions are in mm (in.). 31532-M
107
(4.20)
69
(2.76)
100
(4.0)
90
(3.6)
108
(4.25)