Rockwell Automation 1786-RPFRXL ControlNet Fiber Ring Modules Installation Instructions - Manual (Page 13)

ControlNet Fiber-optic Ring Repeater Modules 13
Rockwell Automation Publication 1786-IN003D-EN-P - April 2011
2. Hook the lip on the rear of the module onto the top of the DIN rail, and
rotate the module onto the rail.
3. Press the module onto the DIN rail until flush.
The locking tab should snap into position and lock the module to the
DIN rail.
4. If the module does not snap into position, use a screwdriver or similar
device to retract the locking tab while pressing the module flush onto the
DIN rail.
5. Release the locking tab to lock the module in place.
If necessary, push the locking tab to lock.
42542
42543