Install the mounting base – Rockwell Automation 1734-IM2_IM4 POINT I/O 220V AC Input Module User Manual
Page 8
Advertising
8 POINT I/O 220V ac Input Module
Publication
1734-IN008C-EN-E - January 2007
Install the Mounting Base
To install the mounting base on the DIN rail, proceed as follows.
1. Position the mounting base vertically above the installed units
(adapter, power supply, or existing module).
2. Slide the mounting base down so that the interlocking side
pieces engage the adjacent module or adapter.
3. Press firmly to seat the mounting base on the DIN rail so that
the mounting base snaps into place.
31586
Slide the mounting base until the
interlocking side pieces engage the
adjacent module or adapter.
Advertising