Barco R9010010 - Manual (Page 35)

4. Connections
How to select the new installed module?
The new installed module can be selected with the digit buttons on the RCU or the local keypad.
4.5.4 Fixed slot (slot 1 & 2)
Where to find?
Slot 1 & 2 has 5 BNC input terminals for 5 cable input and a DVI plug for DVI input. Slot 1 has also an DVI output for loop through
to a second projector. Within the installation mode it is possible to setup the input for 5 cable or DVI (PanelLink).
Which signals can be connected to slot 1 & 2?
Connector name/
Input signal
R G B H V
RGBHV R G B H V
RGBS R G B S -
RGsB R Gs B - -
Composite Video - Video - - -
Super Video - Y - - C
Component Video — SS R-Y Y B-Y S -
Component Video — SOY R-Y Ys B-Y - -
DVI signals can be connected to the DVI input connector.
Pin assignment for the DVI connector.
Pin 1 TMDS DATA2- Pin 13 TMDS DATA3+
Pin 2 TMDS DATA2+ Pin 14 +5 Power
Pin 3 TMDS DATA2/4 Shield Pin 15 Ground (for +5V)
Pin 4 TMDS DATA4- Pin 16 Hot Plug Detect
Pin 5 TMDS DATA4+ Pin 17 TMDS DATA0-
Pin 6 DDC Clock Pin 18 TMDS DATA0+
Pin 7 DDC Data Pin 19 TMDS DATA0/5 Shield
Pin 8 No connect Pin 20 TMDS DATA5-
Pin 9 TMDS DATA1- Pin 21 TMDS DATA5+
Pin 10 TMDS DATA1+ Pin 22 TMDS Clock Shield
Pin 11 TMDS DATA1/3 Shield Pin 23 TMDS Clock+
Pin 12 TMDS DATA3- Pin 24 TMDS Clock-
How to select input slot 1 or 2 ?
1. Key in 1 or 2 on the RCU or the local keypad.
How to change the input slot setting?
1. Press ADJUST or ENTER key to start up the Adjustment mode.
2. Push the cursor key ↑ or ↓ to select Installation. (menu 4-4)
3. Press ENTER.
4. Press the cursor key ↑ or ↓ to select Input Slots. (menu 4-5)
R5976563 BARCOR10 SLM 20/10/2004 31