Barco R9010010 - Manual (Page 55)

6. Start up of the Adjustment mode
6. START UP OF THE ADJUSTMENT MODE
6.1 Start up
Possible paths
There are 3 possible paths to follow once in the Adjustment mode. They are :
•
Installation - Installation should be selected if a new input module is installed or a new source is connected to an existing input
module. Also when the projector is relocated in a new configuration.
• Random Access - Random Access should be selected to set up a new source.
• Service - Service should be selected if the user intends to change general settings such as password, language, address, etc.or
some service actions or get set-up information.
How to start up.
1. Press ADJUST or ENTER to enter the Adjustment mode.
The adjustment mode opens. (menu 6-1)
2. The cursor key (RCU) or ’+ or ’-’ keys (local keypad) are used to make menu selections and also for adjustments.
3. The ENTER and EXIT keys are used to move forward and backward through the menu structure.
4. The ADJUST key can be used to terminate the adjustment mode while any path selection menu is displayed.
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-1
6.2 Password
Password protection of some items.
Some items in the Adjustment mode are password protected. While selecting such an item, the projector asks to enter your password
(Password protection is only available when the password strap on the controller module is ON, call an authorized service center to
change the position of the password strap).
R5976563 BARCOR10 SLM 20/10/2004 51