Dual trunk e1 router – Black Box LRU4240 User Manual
Page 124
112
SALES: 0118 965 5100
Dual Trunk E1 Router User’s Guide
Dual Trunk E1 Router
4V
Timezone configuration
Set unit's local time. This menu works in conjunction with GMT Time Sync
menu-4T (RFC-868).
When RFC 868 is used to get time, time server provides GMT. If a unit is
deployed in different time zone user needs to configure the units
appropriately.Day light savings ends in October.
6A
MLFR Configuration
View and set the following Multilink Frame Relay configuration
parameters: Link Integrity Timer, Link Acknowledge, and Retry Counter.
6A
PPP/MLPPP Unit
configuration
View and set PPP configuration parameters.
6B
MFR port configuration
View link status and protocol errors per link.
6B
PPP/MLPPP Port Status
View link status and protocol errors per link.
6Z
Timeslot Configuration
Fractional E1 speed configuration and port mapping to Ethernet data port.
7
Features
Reserved for software feature key upgrades.
8
Alarm
Alarm Selection submenu.
8A
Alarm Configuration
Allows user to enable/disable alarms and to set alarm thresholds.
8C
Miscellaneous Management
Configuration
Dial out, passwords, alarm port settings.
8E
Modem Initialization Strings
Setting menu for modem initialization strings.
8F
Comm port configuration
Configure the comm port speed
8G
User authentication server
Configure Radius authentication protocol. See
“Configuring Radius
Authentication” on page 36
36
8O
Reboot the unit
Rebooting the unit remotely using TUI menu
9
Diagnostics
Tests and diagnostics selection menu.
9A
Physical Layer Diagnostics
E1 Net testing by patterns, loop, selecting loop codes on/off.
9B
Link Layer Diagnostics
Menu for In-band testing.
9C
Delay Monitoring
Configuration
Configuration for Delay Monitoring. Results are displayed in Menu-3M.
$
Routing Configuration
Main router configuration menu
$A
Unit Routing configuration
Configuration routing mode, default gateway IP address, enable Firewall,
and Load balancing.
$B
Display routing table
View routing configuration tables (static and dynamic routes)
$C
Static routing table
Configure static routes.
$E
Routing Command Line
Interface (CLI)
Allows you to configure the dynamic routing protocols (RIP1, RIP2, and
OSPF) See
“Kernel Command Reference” on page 164
.
$F
Display ARP Table
View ARP cache table.
$H
Firewall Table
Configure access lists.
Table D-1 Router Menus (4 of 5)
Menu
Number Name
Description
Page