Menu-8 alarm, Menu-8a alarm configuration, Menu-8c miscellaneous management configuration – Black Box LRU4240 User Manual

Page 98: Menu-8e modem initialization strings, Dual trunk e1 router

Advertising
background image

86

SALES: 0870 90 10 750

Dual Trunk E1 Router User’s Guide

Dual Trunk E1 Router

Menu-8 Alarm

Menu-8, Alarm, provides access to four sub-menus:

• Alarm Configuration
• Miscellaneous Management Configuration
• Modem Initialization Strings
• COMM Port Configuration

Select the corresponding option to view and configure parameters for alarm configuration, external
alarm configuration, for miscellaneous management configuration, and modem initialization strings.
For more information on Menu 8, see the 4200 WAN Access Platform TUI Reference Guide.

Menu-8A Alarm Configuration

When you select Alarm Configuration, Menu 8A appears. Menu 8A allows you enable or block
alarm reporting, and select if alarms associated with the Ethernet signal will be reported.

Menu-8C Miscellaneous Management Configuration

When you select Miscellaneous Management, Menu-8C appears. Menu 8C allows you to
configure a variety of parameters including connection, phone numbers, timing and error thresholds.

Menu-8E Modem Initialization Strings

If you select Modem Initialization Strings, Menu 8E appears Each unit can have a maximum of
two modem initialization strings. The first string (

String 1

) can be equal to or less than 20

characters, and the second string (

String 2

) can be equal to or less than 60 characters.

To initiate a modem connection:

1. The unit sends

+++

, followed by the first modem initialization string.

2. The unit then waits for a response from the modem to guard against the possibility of

losing the characters immediately after the modem resets.

3. After receiving the modem response, the unit sends the second initialization string (if

this string is programmed). The Dual Trunk E1 Router assumes that the modem always
sends a response; therefore, do not
program the modem not to send a response.

4. If using the modem reset command, you should program everything up to the reset

command as the first modem initialization string.

5. Program the remaining commands as the second modem initialization string.

Advertising