Black Box LRU4240 - Manual (Page 175)

Dual Trunk E1 Router
Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 163
AREAID=A.B.C.D|<0-4294967295>
A.B.C.D= The IPv4 specification of the address for the stub.
<0-4294967295>= The area identification number for the stub.
NAME The name of the configured access list.
Command Mode: Router mode
Usage
In conjunction with IP access list, this command is used to configure routes outside the area that will be advertised into this area.
This command is only applied when generating summary LSAs (type 3).
Examples
ospfd# configure terminal
ospfd(config)# access-list list1 deny 172.22.0.0/8
ospfd(config)# router ospf 100
ospfd(config-router)#area 1 import-list list1
Related Commands
access list
area range
Use the area range command to summarize OSPF routes at an area boundary.
Use the no form of this command to disable this function.
Command Syntax
area AREAID range ADDRESS (advertise|not-advertise|SUBSTITUTE)
no area AREAID range
AREAID= A.B.C.D|<0-4294967295>
A.B.C.D= The IPv4 address specification of the address for the stub.
<0-4294967295>= The area identification number for the stub.
ADDRESS= A.B.C.D/M The area range prefix and length.
advertise Advertises this range.
not-advertise Does not advertise this range.
SUBSTITUTE = substitute A.B.C.D/M Announce area range as another prefix.
A.B.C.D/M = Network prefix to be announced instead of range.
Default
Disabled
Command Mode
Router mode
Usage
The area range command is used to summarize intra-area routes for an area. The single summary route is then advertised to other
areas by the Area Border Routers (ABRs). Routing information is condensed at area boundaries and outside the area. If the
network numbers in an area are assigned in a way such that they are contiguous, the ABRs can be configured to advertise a
summary route that covers all the individual networks within the area that fall into the specified range.
Examples
ospfd# configure terminal
ospfd(config)# router ospf 100
ospfd(config-router)# area 1 range 192.16.0.0/24
Related Commands
area shortcut
Use the area shortcut command to configure the short-cutting mode of an area.
Use the no form of this command to disable this function.
Command Syntax
area AREAID shortcut (default|enable|disable)
no area AREAID shortcut (enable|disable)
AREAID= A.B.C.D|<0-4294967295>
A.B.C.D= The IPv4 address specification of the address for the stub.