Black Box LRU4240 - Manual (Page 47)

Dual Trunk E1 Router
Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 35
C
ONFIGURING
LAN I
NTERFACE
S
ETTING
ID, D
ATE
, T
IME
,
AND
N
ETWORK
T
IMING
Unit Configuration − Menu 4A
Figure 4-1 shows Menu 4A Unit Configuration. The numbers in circles correspond to the
procedures for setting the parameters in each field.
Figure 4-1Menu 4A, Unit Configuration
Table 4-3 Menu-4A- Unit Configuration
Table 4-2 Configuring LAN interface
Procedure Steps
Setting Ethernet port speed To configure the ethernet speed to 10MB/Half or 10MB/Full.
1.Select Menu-0C
2.Select Data/Speed Mode
3.Select 10MB/Half or 10MB/Full setting. The default value is
10MB/Half.
Modifying Ethernet port IP address 1.Select Menu-0A
2.Select ENET IP Address/Len field
3.Enter the assigned Ethernet port IP Address and the subnet mask
Parameter Description
UNIT ID Field Local
1 ( Alphanumeric field identifier at the top of the menu)
The Dual Trunk E1 Router comes factory configured with a unique unit ID. Each
Dual Trunk E1 router in your network must have a unique Unit ID. You may use the
preconfigured Unit ID or change it to a combination of 6 alpha and numeric
characters, but the first character must be an alpha character.
1
3
2