Black Box LRU4240 - Manual (Page 156)

144 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide
Dual Trunk E1 Router
<A.B.C.D> IP address in standard form
<Len> The subnet mask 1 to 32, the part of the IP address shared by all devices on the network.
Command Mode: Config
interface enet
Use the interface enet command to set ethernet port parameters including mask length, half or full duplex mode, and promiscuous
mode
Command Syntax:
interface enet bcast-mask <1-32>
Set the mask length for Net directed IP broadcast in Fast Forwading mode.
Usage: Use this command in IP Fast Forwarding mode only.
interface enet data-mode [full-duplex | half-duplex]
Set physical data mode to half or full-duplex.
interface enet fwd-multicast [disabled | enabled]
Enable or disable forwarding of multicast packets in IP Fast Forwarding mode.
Usage: This command is applicable in Fast Forwarding mode only.
interface enet promiscuous [disabled | enabled]
To enable or disable promiscuous mode in Bridging mode.
Usage: Use this command in Bridging mode only.
interface enet proxy-arp [disabled | enabled]
To enable or disable proxy-arp in Fast-forwarding mode.
Usage: Use this command in Fast Forwarding mode only.
interface frame-relay dlci
Use the interface frame-relay dlci clear command to enter the DLCI number for a virtual cirtuit idendifier and the network port
on which this DLCI is connected.
Command Syntax: interface frame-relay dlci <16-1023> [net 1 | net2 | bundle0]
<16-1023> dlci range
net1, net2, or bundle 0 Network interface on which the DCLI is connected
Command Mode: Config
Example
Unit(config)#interface frame-relay dlci 20 net1
interface frame-relay lmi
Use the interface frame-relay lmi command to enable or disable LMI and configure LMI parameters.
Command Syntax: interface frame-relay lmi [disabled | enabled | enquiry-rx-timer | enquiry-tx-timer | full-status-count | max-lmi-
errir | type | unit-location]
disabled Disable LMI Conditioning
enabled Enable LMI Conditioning
enquiry-rx-timer <5-30> Set the expected interval in 5 seconds increments between expected receive enquiry status
message
enquiry-tx-timer <5-30> Set the interval in 5 seconds increments between the sending of a STATUS ENQUIRY and the
receipt of a response.
full-status-count <5-30> Set the interval in 5 seconds increments between the sending of a STATUS ENQUIRY and the
receipt of a response.
max-lmi-error <5-30> Set the interval in 5 seconds increments between the sending of a STATUS ENQUIRY and the
receipt of a response.
unit-location [CPE | CO]
Command Mode: Config