Hazardous location considerations, Low voltage directive -2, Hazardous location considerations -2 – Rockwell Automation 1746-NO8V SLC 500 8-Point Analog Output Module/ User Manual User Manual
Page 10
Publication 1746-UM026A-EN-P - September 2003
2-2 Installation and Wiring
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low
Voltage, by applying the safety requirements of EN 61131-2
Programmable Controllers, Part 2 – Equipment Requirements and
Tests.
For specific information required by EN61131-2, see the appropriate
sections in this publication, as well as the following Allen-Bradley
publications:
•
Industrial Automation, Wiring and Grounding Guidelines for
Noise Immunity, publication 1770-4.1
•
Automation Systems Catalog, publication B113
Hazardous Location
Considerations
This equipment is suitable for use in Class I, Division 2, Groups A, B,
C, D or non-hazardous locations only. The following ATTENTION
statement applies to use in hazardous locations.
ATTENTION
!
EXPLOSION HAZARD
•
Substitution of components may impair suitability
for Class I, Division 2.
•
Do not replace components or disconnect
equipment unless power has been switched off.
•
Do not connect or disconnect components unless
power has been switched off.
•
This product must be installed in an enclosure.