Rockwell Automation 1746-NO8V SLC 500 8-Point Analog Output Module/ User Manual - Manual (Page 30)

Publication 1746-UM026A-EN-P - September 2003
4-6 Configuring the Module
Configuring Each Output
Channel Class 1 and Class 3 Configuration
Output words 0 through 7 (addresses O:e.0 through O:e.7) hold the
output data for channels 0 through 7 respectively.
Class 3 Configuration
After installing the module, you must configure each channel by
setting bit values in each configuration word. Output words 8 through
15 (addresses O:e.8 through O:e.15) configure channels 0 through 7
respectively.
Figure 4.1 1746-NO8 Output Addressing
Output Image Function
Output Data
Class 3
Class 1
O:e.0 Channel 0
O:e.1 Channel 1
…
O:e.6 Channel 6
O:e.7 Channel 7
Configuration
Output
O:e.8 Channel 0
O:e.9 Channel 1
…
O:e.14 Channel 6
O:e.15 Channel 7
Output Data
Parameter 1
O:e.16 Channel 0
O:e.17 Channel 1
…
O:e.22 Channel 6
O:e.23 Channel 7
Output Data
Parameter 2
O:e.24 Channel 0
O:e.25 Channel 1
…
O:e.30 Channel 6
O:e.31 Channel 7