Rockwell Automation 1746-NO8V SLC 500 8-Point Analog Output Module/ User Manual - Manual (Page 9)

1 Publication 1746-UM026A-EN-P - September 2003
Chapter
2
Installation and Wiring
This chapter tells you how to:
•
avoid electrostatic damage
•
determine the chassis power requirement for the module
•
use an external 24V dc power supply (optional)
•
choose a location for the module in the SLC chassis
•
install and remove the module
•
wire the module’s terminal block
•
label and re-install the terminal block
Compliance to European
Union Directives This product is approved for installation within the European Union
and EEA regions. It has been designed and tested to meet the
following directives.
EMC Directive
The analog modules are tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards, in
whole or in part, documented in a technical construction file:
•
EN 50081-2
EMC – Generic Emission Standard, Part 2 - Industrial
Environment
•
EN 50082-2
EMC – Generic Immunity Standard, Part 2 - Industrial
Environment
This product is intended for use in an industrial environment.