Rockwell Automation SA500 AC Power Modules User Manual
Page 17
Power Module Mechanical Description
2-5
.
.
AUX IN1 (green) -
When lit, this LED indicates the presence of a 115 volt signal
on this input (pin C). This LED is used for M-contactor
feedback when the programmer has configured an output
contactor between the Power Module and the motor. The use
of an M-contactor is optional.
Corresponding bit location: Register 201/1201, bit 1.
AUX IN2 (green) -
When lit, this LED indicates the presence of a 115 volt signal
on this input (pin E).
Corresponding bit location: Register 201/1201, bit 2.
AUX IN3 (green) -
When lit, this LED indicates the presence of a 115 volt signal
on this input (pin H).
Corresponding bit location: Register 201/1201, bit 3.
AUX IN4 (green) -
When lit, this LED indicates the presence of a 115 volt signal
on this input (pin K).
Corresponding bit location: Register 201/1201, bit 4.
AUX IN5 (green) -
When lit, this LED indicates the presence of a 115 volt signal
on this input (pin M).
Corresponding bit location: Register 201/1201, bit 5.
AUX OUT (amber) -
When lit, this LED indicates the output signal has been
turned on (pin S).
Corresponding bit location: Register 101/1101, bit 4.