Rockwell Automation SA500 AC Power Modules - Manual (Page 71)

Compliance with Electromagnetic Compatibility Standards H-1
A
PPENDIX
H
Compliance with Electromagnetic
Compatibility Standards
H.1 Introduction
This appendix provides information on the SA500 DC Bus Supplies and AC Power
Modules’ compliance with European Community electromagnetic compatibility (EMC)
standards and covers the following:
• requirements for standards compliance
• guidelines on installing the equipment
• instructions on how the drive must be wired.
The SA500 DC Bus Supplies and AC Power Modules listed on the Declaration of
Conformity (DOC) (Ref: Drawing 422802-201) have been tested and are in
compliance with the following standards when installed as described in this manual
and amended herein:
• EN55011 (1991) Limits and methods of measurement of radio disturbance
characteristics of industrial, scientific, and medical (ISM) radio-frequency
equipment.
• EN50082-2 (1995) Electromagnetic Compatibility - Generic Immunity Standard
Part 2: Industrial Environment
Note that the conformity of the SA500 DC Bus Supplies and AC Power Modules to the
above standards does not guarantee that the entire installation will be in conformance.
For a copy of the Declaration of Conformity, contact your local Rockwell Automation
sales office.
H.2 Compliance Requirements
In order for the SA500 DC Bus Supplies and AC Power Modules to conform to the
standards listed in section H.1, the equipment must:
• be accompanied by the DOC (Ref: Drawing 422802-201).
• have a CE mark. This mark is found on the product.
• be mounted inside a cabinet.
• be powered through a EMI line filter.
• be installed in accordance with the instructions in this appendix.
If these conditions are not met and CE conformity is desired, contact your local
Rockwell Automation Drive Systems Sales Representative.