Rockwell Automation SA500 AC Power Modules - Manual (Page 34)

4-6 SA500 Power Modules
4.3 Fiber-Optic Connection
Refer to the Distributed Power System Fiber-Optic Cabling instruction manual
(S-3009) for the procedure required to install and test the fiber-optic cable between the
Power Module and the UDC module.
The Power Module is shipped with dust caps covering the fiber-optic ports. The dust
caps should not be removed until the fiber-optic cables are installed and should be
replaced if the cables are disconnected.
4.4 Drive I/O Connections
The Drive I/O Cable (M/N 612401-T) provides the connection between the Drive I/O
connector and a 16-point terminal block. The cable has an 18-pin connector on one
end for connection to the Drive I/O Connector. Near the connector, the cable is labeled
“C3-P2.” Near the terminal block connections, the cable is labeled “I/O.” Refer to
figure 4.3 for the terminal block connections.
!
ATTENTION: Turn off, lock out, and tag power to both the rack containing
the UDC module and to its corresponding PMI hardware before viewing
the fiber-optic cable or transmitter under magnification. Viewing a
powered fiber-optic transmitter or connected cable under magnification
may result in damage to the eye. For additional information refer to ANSI
publication Z136.1-1981. Failure to observe this precaution could result
in bodily injury.