Rockwell Automation 1606-XLP XM Electronic Overspeed Detection System - Manual (Page 21)

Publication GMSI10-UM015B-EN-E - June 2011
Installing the XM Electronic Overspeed Detection System 21
1. Position the XM-946 terminal base on the 35 x 7.5mm DIN rail (A)
(A-B pt no. 199-DR1 or 199-DR4).
2. Slide the terminal base unit over leaving room for the side
connector (B).
3. Rotate the terminal base onto the DIN rail with the top of the rail
hooked under the lip on the rear of the terminal base.
4. Press down on the terminal base unit to lock the terminal base on the
DIN rail. If the terminal base does not lock into place, use a screwdriver
or similar device to open the locking tab, press down on the terminal
base until flush with the DIN rail and release the locking tab to lock the
base in place.
Position terminal base at a slight angle and hook over the top of the DIN rail.