Bendix Commercial Vehicle Systems EC-60 ESP CONTROLLERS ADV - Manual (Page 17)

17
REMOVING THE BENDIx ® EC-60 ™
CONTROLLER ASSEMBLY
1. Turn vehicle ignition off.
2. Remove as much contamination as possible prior to
disconnecting electrical connections.
3. Note the Bendix EC-60 controller assembly mounting
position on the vehicle.
4. Disconnect the electrical connectors from the Bendix
EC-60 controller.
5. Remove and retain the mounting bolts that secure the
Bendix EC-60 controller.
CAUTION
The VIN of the vehicle is stored in the ECU internal
memory, and is cross-checked by the ECU using
information obtained from other vehicle controllers .
If the VIN stored in the ECU does not match the VIN
obtained from the other vehicle controller, the ECU will
generate an ECU Internal VIN Mismatch DTC .
Accordingly, do not switch Advanced controllers from
one vehicle to another .
Troubleshooting: General