Brew Express BE-110 INSTALLATION - Manual (Page 17)

MOUNTING
SCREWS
14
BrEwEr INSTALLATION
3" max
Power Panel
8. The male quick connector has a built in valve so water can be
turned on prior to connection to coffee maker. Place unit on
a towel or cardboard to protect counter surface. Place
BREW EXPRESS directly in front of rough-in box. Connect
brewer to water supply using quick connectors. (See Quick
Connect Detail). Snap connectors together firmly. Turn on
water, check for leaks prior to final installation of
BREW EXPRESS. If leaking, turn off water, tighten connections
or reinstall quick connector. Turn water on and check again.
See Figure 8.
Quick Connect Detail
Figure 8
9. Gently slide the BREW EXPRESS into the rough-in-box.
Be careful not to damage water supply lines. A firm push will
connect power from rough-in-box to the BREW EXPRESS.
Use two mounting screws to secure BREW EXPRESS
to rough-in-box. Note, the lock bracket and longer screw go
in the upper position (on some models the two screws will
be the same length).
WARNING:
Do not caulk or grout to brewer.