Brew Express BE-110 INSTALLATION - Manual (Page 9)

12 1/4" 312.4mm
13 3/8"
340mm
3 7/8" 96.9 mm
11 3/8"
289.3mm
6 1/4" 158.3mm
11 1/4" 286.9 mm
3 7/8" 98.0 mm
1/2” 12.8 mm
11 1/2" 292.1 mm
AREA ON WALL
TO BE CUT
(USE TEMPLATE)
5/8" 15.7 mm
11 1/2"
292.1 mm
BE-110 SPECIFICATIONS:
(Specs for the BE-104 are on page 5)
Read and follow instructions carefully before installing your BREW EXPRESS in-the-wall
COFFEE SYSTEM. For best results, it is advised that you hire a qualified professional.
1. Overall Dimensions (Finished Unit with Rough-in-Box) approximately 12 1/4” X 13 3/8” (see below).
2. Dimensions for Rough-in-Box (Mounting Structure) approximately 11.5” X 11.5”.
3. Electrical Requirements 120VAC, 60HZ. (1400 watts).
4. Water Requirements 1/4” OD water supply line (copper or poly) minimum 30 psi to a maximum of
90 psi. Potable COLD water is required.
NOTE: If water is not available, an alternate water dispenser jug (5 gallons) can be used with the
optional pump accessory (not supplied). Contact Lance Larkin for more information.
Please Note: A filter and shut off valve at water source is recommended. The filter, such as an ice maker type filter,
can easily be installed at the source. If water lines are not purged or clear of debris or a filter is NOT installed, foreign
particles (debris) in water may clog brewer system causing failure, and will void all warranties.
SpECIfICATIONS AND rEqUIrEmENTS
6