brite-View Air SyncHD BV-2322 User Manual - Manual (Page 10)

9
C. Remote Controller Unit (RCU) Instruction
Note :
1.
Press Power key pointed at the transmitter when system on active mode, transmitter will
enter Listen mode (RF disconnected) and Loop-through display keeps on.
2.
Press Power key Point at the receiver when system on active mode, both transmitter and
receiver will enter Standby mode (RF disconnected) and Loop-through display off.
3.
The “Standby” mode uses consumes 90% less of the power. User has to press both power key
on transmitter and receiver to resume active mode.
Button Function Description Operation
POWER
Press to turn the
BV-2322
Transmitter/Receiver
on/off.
Press it when pointing at the
BV-2322R to enter the
"Standby
Mode" with the loop-through
connection is already on;
press
it when pointing at the
BV-2322T to enter the
"Standby Mode
" with the loop-through
connection is off.
INFO.
Press to display between
"Channel", "Source",
"Resolution", "WIDE
mode" and ' Signal
Quality'
Press once to display the
current status.
Press again to exit OSD.
SOURCE
Press this button to
change the frequency
of IR blaster among
38KHz, 47Kz and
58KHz. Default frequency
is 47KHz .
Press once to display the
current frequency of IR
blaster.
Press again to change to next
frequency, and the frequency
will be displayed on the OSD.
CHANN
EL
Press this button to
change between
wireless channels
manually if the user
experiences video noise.
Press once to display the
current "Channel" status.
Press again within 5 seconds
to switch to another channel,
and
the channel number will be
displayed on the OSD.
WIDE
Enable the “WIDE” mode
to boost transmission
distance; up to 100 feet
(1080i content only)
Press this button to enable
and disable Wide mode.
Press again within 5 seconds
to enable WIDE mode, and
the status will be displayed
on OSD.